3Com MSR 30, MSR 50 manual Ani-offset, Answer enable, Syntax ani-offset number Undo ani-offset

2648 CHAPTER 175: E1 AND T1 CONFIGURATION COMMANDS

ani-offset

Syntax ani-offset number

undo ani-offset

View R2 CAS view

Parameter number: Number of digits to be collected, in the range of 1 to10.

Description Use the ani-offsetcommand to configure the number of called number digits that need to be collected prior to requesting calling party information.

Use the undo ani-offsetcommand to restore the default value.

Before adequate digits are collected, the system will wait for the next digit until the timer expires. During this period, the system does not request calling party information. It does that only after adequate digits are collected.

By default, the number of digits to be collected before the calling party information is 1.

This command applies to R2 signaling only.

Related command: cas, timer, reverse, and renew.

Example # Start requesting calling number or caller identifier after receiving three digits.

<Sysname> system-view [Sysname] controller e1 1/0

[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2 [Sysname-e1 1/0] cas 0

[Sysname-cas1/0:0] ani all

[Sysname-cas1/0:0] ani-offset 3

answer enable

Syntax answer enable

undo answer enable

View R2 CAS view

Parameter None

Description Use the answer enable command to configure the originating point to require the terminating point to send answer signal. Only after receiving an answer signal can the two parties begin to talk.

Use the undo answer enable command to restore the default.