1837

117

QOS TOKEN CONFIGURATION

COMMANDS

qos qmtoken

Syntax

qos qmtoken token-number

 

undo qos qmtoken

View

Interface view

Parameters

token-number: The number of transmitted tokens, in the range 1 to 50.

Description

Use the qos qmtoken command to configure the number of transmitted tokens.

 

Use the undo qos qmtoken command to disable the token transmission

 

function of QoS.

 

By default, the function of QoS is disabled.

 

During an FTP transfer, flow control provided by the upper layer protocol can

 

invalidate the configuration of QoS queuing. To resolve this problem, the token

 

transmission function of QoS was introduced. This function provides a flow control

 

mechanism at the underlying-layer queuing level. It can control the number of

 

packets sent to the underlying interface queues based on the number of tokens.

 

If FTP applies, you are recommended to set the number of tokens sent by an

 

interface to 1.

n

After you configure this command on an interface, you must perform

shutdown and undo shutdown on the interface to have the function take

 

effect.

 

So far, this command is supported only by Ethernet, serial, and BRI interfaces.

Examples

# Set the number of transmitted tokens to 1.

 

<Sysname> system-view

 

[Sysname] interface serial 2/0

 

[Sysname-Serial2/0] qos qmtoken 1

Page 1837
Image 1837
3Com MSR 50, MSR 30 manual 117, QOS Token Configuration Commands, Qos qmtoken token-number, Undo qos qmtoken