3Com MSR 30, MSR 50 manual Dialer threshold, Example

324CHAPTER 20: DCC CONFIGURATION COMMANDS

interface interface-type interface-number: Specifies to dial from the specified physical interface. When multiple physical interfaces are assigned to a dialer interface and their dialup links are connected to different ISDN switches, you need to associate the dialup numbers with the physical interfaces. This configuration is intended for dialer interfaces in C-DCC only.

Description Use the dialer route command to enable a DCC interface to call the specified destination address (host or network address) or to receive calls from multiple remote ends.

Use the undo dialer route command to remove a dialer route.

n

Example

To enable DCC to originate calls, you need to configure the dial-numberargument.

If the user keyword is used, PPP authentication must be configured.

You may configure multiple dialer routes on a dial interface or for a destination address for the backup purpose.

If the dialer-groupcommand is not configured, DCC will not dial.

# Dial 888066 to set up link for packets destined to network 192.168.1.0/24.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] dialer route ip 192.168.1.0 mask 24 888066

# Dial 888065 to set up link for packets destined to host address 192.168.1.1.

[Sysname-Serial2/0] dialer route ip 191.168.1.1 888065

dialer threshold

Syntax dialer threshold traffic-percentage[ in in-out out ]

undo dialer threshold

View Dialer interface view

Parameter traffic-percentage: Percentage of actual traffic on the link to bandwidth, in the range 0 to 99.

in: Considers only inbound traffic in actual load calculation.

in-out: Considers either inbound traffic or outbound traffic in actual load calculation, whichever is greater.

out: Considers only outbound traffic in actual load calculation.