3Com MSR 30, MSR 50 manual Frame-format g751-adm g751-plcp g832-adm

124CHAPTER 3: ATM E3/T3 INTERFACE CONFIGURATION COMMANDS

Use the undo clock command to restore the default, that is, the slave clock mode.

Example # Set the clock mode of ATM E3/T3 interface 5/0 to master.

<Sysname> system-view [Sysname] interface atm 5/0 [Sysname-Atm5/0] clock master

frame-format

Syntax	In ATM E3 interface view:
	frame-format { g751-adm g751-plcp g832-adm }
	In ATM T3 interface view:
	frame-format { cbit-adm cbit-plcp m23-adm m23-plcp }
	undo frame-format
View	ATM E3/T3 interface view
Parameter	g751-adm: Sets the framing format of ATM E3 to G.751 ATM direct mapping
	(G.751 ADM).
	g751-plcp: Sets the framing format of ATM E3 to G.751 physical layer
	convergence protocol (G.751 PLCP).
	g832-adm: Sets the framing format of ATM E3 to G.832 ADM.
	cbit-adm: Sets the framing format of ATM T3 to C-bit ADM.
	cbit-plcp: Sets the framing format of ATM T3 to C-bit PLCP.
	m23-adm: Sets the framing format of ATM T3 to M23 ADM.
	m23-plcp: Sets the framing format of ATM T3 to M23 PLCP.
Description	Use the frame-formatcommand to configure the framing format of the ATM
	E3/T3 interface.
	Use the undo frame-formatcommand to restore the default, that is, G.751
	PLCP for ATM E3 interfaces and C-bit PLCP for ATM T3 interfaces.
Example	# Set the framing format of ATM E3 interface 5/0 to G.832 ADM.
	<Sysname> system-view
	[Sysname] interface atm 5/0
	[Sysname-Atm5/0] frame-format g832-adm