3Com MSR 30 Timer hello PIM view, Timer join-prune PIM view, Related command pim timer hello

1428 CHAPTER 90: PIM CONFIGURATION COMMANDS

■You can configure up to 50 static RPs on the same device.

Related command: display pim rp-infoand auto-rp enable.

Example # In the public instance, configure the interface with the IP address 11.110.0.6 to be a static RP that serves the multicast groups defined in ACL 2001, and give priority to this static RP in the case of static/dynamic RP conflict.

<Sysname> system-view [Sysname] pim

[Sysname-pim] static-rp 11.110.0.6 2001 preferred

timer hello (PIM view)

Syntax timer hello interval

undo timer hello

View Public instance PIM view, VPN instance PIM view

Parameter interval: Hello interval in seconds, with an effective range of 1 to 2,147,483,647.

Description Use the timer hello command to configure the hello interval globally.

Use the undo timer hello command to restore the default setting.

By default, hello messages are sent at the interval of 30 seconds.

Related command: pim timer hello.

Example # Set the global hello interval to 40 seconds in the public instance.

<Sysname> system-view [Sysname] pim [Sysname-pim] timer hello 40

timer join-prune (PIM view)

Syntax timer join-prune interval

undo timer join-prune

View Public instance PIM view, VPN instance PIM view

Parameter interval: Join/prune interval in seconds, with an effective range of 1 to 2,147,483,647.

Description Use the timer join-prunecommand to configure the join/prune interval globally.