3Com MSR 50 Rip summary-address, Rip triggered, Related commands summary, Syntax rip triggered

1179

■In special cases, make sure it is necessary to disable the split horizon function.

■In Frame Relay, X.25 and other non-broadcast multi-access (NBMA) networks, split horizon should be disabled if multiple VCs are configured on the primary and secondary interfaces to ensure route advertisement. For detailed information, refer to “Frame Relay Configuration Commands” on page 371 and “LAPB and X.25 Configuration Commands” on page 421.

n Only the poison reverse function takes effect if both the split horizon and poison reverse functions are enabled.

Examples # Enable the split horizon function on Ethernet1/0.

<Sysname> system-view

[Sysname] interface ethernet1/0

[Sysname-Ethernet1/0] rip split-horizon

rip summary-address

Syntax rip summary-addressip-address { mask mask-length }

undo rip summary-addressip-address { mask mask-length }

View Interface view

Parameters ip-address: Summary IP address.

mask: Subnet mask in dotted decimal format.

mask-length: Subnet mask length.

Description Use the rip summary-addresscommand to configure RIP-2 to advertise a summary route via the interface.

Use the undo rip summary-addresscommand to remove the configuration.

Note that the summary address is valid only when the automatic summarization is disabled.

Related commands: summary.

Examples # Advertise a local summary IP address on Ethernet1/0.

<Sysname> system-view

[Sysname] interface ethernet1/0

[Sysname-Ethernet1/0] rip summary-address 10.0.0.0 255.255.255.0

rip triggered

Syntax rip triggered