3Com MSR 50, MSR 30 manual Display clock, Command-privilege level level view view command

	2409
	After the configuration takes effect, use the display clock command to view the
	result. The information such as log file and debug adopts the local time modified
	by time-zone and daylight saving time.
Related command:	clock datetime, clock summer-timeone-off,clock summer-time repeating,
	display clock.
Example	# Set the name of the local time zone to Z5, five hours ahead of UTC time.
	<Sysname> clock timezone z5 add 5
command-privilege
Syntax	command-privilege level level view view command
	undo command-privilege view view command
View	System view
Parameter	level level: Specifies a command level in the range 0 to 3.
	view view: Specifies a view.
	command: Command to be set in the specified view.
Description	Use the command-privilegecommand to assign a level for the commands in
	the specified view.
	Use the undo command-privilege view command to restore the default.
	By default, the commands under each view have their respective command levels.
	Generally, do not modify the default command levels to avoid inconvenience to
	your maintenance and operation.
	Command privilege falls into four levels: visit, monitor, system, and manage,
	which are identified by 0 through 3.
	The administrator can assign a privilege level for a user according to his need.
	When the user logs on a device, the commands available depend on the user’s
	privilege. For example, if a user’s privilege is 3 and the command privilege of VTY 0
	user interface is 1, and the user logs on the system from VTY 0, he can use all the
	commands with privilege smaller than three (inclusive).
	The following table describes the default level of the commands.

Table 622 Default level of the commands

Command level	Commands
Visit (0)	ping, tracert, telnet
Monitor (1)	refresh, reset, send
System (2)	Configuration commands