3Com MSR 50, MSR 30 manual Display fr vofr-info, Interface Dlci view, Related command Vofr Example

				2713
View	Interface DLCI view
Parameter	max-poll: Selects circuit IDs cyclically in descending order
	min-poll: Selects circuit IDs cyclically in ascending order
Description	Use the cid select-modecommand to configure the CID selection mode which
	the originating side of a VoFR call adopts.
	Use the undo cid select-modecommand to restore the default.
	By default, CIDs are cyclically selected in descending order.
	In the dynamic mode, it is possible that multiple voice channels share one DLCI.
	The same CID at both ends may lead to a call collision. To prevent call collisions,
	you may configure different CID selection modes at both ends
Related command:	vofr.
Example	# Set the CID selection mode to min-poll on DLCI 100.
	<Sysname> system-view
	[Sysname] interface serial 1/0
	[Sysname-Serial1/0] fr dlci 100
	[Sysname-fr-dlci-100] cid select-mode min-poll
display fr vofr-info
Syntax	display fr vofr-info[ serial interface-number [ dlci-number ] ]
View	Any view
Parameter	serial interface-number: Displays the FRF.11 sub-channel information on a
	specified interface.
	dlci-number: Virtual circuit number, in the range of 16 to 1007
Description	Use the display fr vofr-infocommand to display the FRF.11 sub-channel
	information on a VoFR DLCI. You can use the display fr vofr-info serial
	interface-numbercommand to display the FRF.11 sub-channel information on a
	specified interface sub-interface. The information of all FRF.11 sub-channels will be
	displayed if no interface sub-interface is specified. You can use the display fr
	vofr-infodlci-numberto display the FRF.11 sub-channel information on a
	specified DLCI.
Example	<Sysname> display fr vofr-info
	interface(dlci)	vofr-mode	cid	cid-type
	Serial2/0:0(100)	vofr-nonstandard	5	frag-data
	Serial2/0:0(100)	vofr-nonstandard	4	voice-signal