1484 CHAPTER 93: IPV6 PIM CONFIGURATION COMMANDS

MTU of the network. As a result, the products that do not support fragmentation will drop the join/prune message.

The (S, G) join/prune state hold time on the upstream device. If you configure a small queue size, the outgoing interface of the corresponding entry may have been pruned due to timeout before the last join/prune message in a queue reaches the upstream device.

Related commands: jp-pkt-size (IPv6 PIM view), holdtime join-prune (IPv6 PIM view), pim ipv6 holdtime join-prune.

Example # Configure a join/prune messages to contain a maximum of 2,000 (S, G) entries.

<Sysname> system-view

[Sysname] pim ipv6

[Sysname-pim6] jp-queue-size 2000

pim ipv6

Syntax pim ipv6

undo pim ipv6

View System view

Parameter None

Description Use the pim ipv6 command to enter IPv6 PIM view.

Use the undo pim ipv6 command to remove all configurations performed in IPv6

PIM view.

IPv6 multicast must be enabled on the device before this command can take effect.

Related command: multicast ipv6 routing-enableon page 1440.

Example # Enable IPv6 multicast routing and enter IPv6 PIM view.

<Sysname> system-view

[Sysname] multicast ipv6 routing-enable

[Sysname] pim ipv6

[Sysname-pim6]

pim ipv6 bsr-boundary

Syntax pim ipv6 bsr-boundary

undo pim ipv6 bsr-boundary

Page 1484
Image 1484
3Com MSR 30 Pim ipv6 bsr-boundary, Syntax pim ipv6 Undo pim ipv6, Related command multicast ipv6 routing-enableon