3Com MSR 50, MSR 30 manual Mpls te timer fast-reroute, Mpls te timer retry, 1635

1635

<Sysname> system-view [Sysname] mpls

[Sysname-mpls] mpls te timer auto-bandwidth 600

mpls te timer fast-reroute

Syntax mpls te timer fast-reroute [ seconds]

undo mpls te timer fast-reroute

View MPLS view

Parameter seconds: FRR polling timer setting for the point of local repair (PLR) to poll available bypass tunnels for the best one. It ranges from 0 to 604800 seconds, with 0 disabling the PLR to poll available bypass tunnels regularly for the best one. The default is 300 seconds or 5 minutes.

Description Use the mpls te timer fast-reroutecommand to set the FRR polling timer.

Use the undo mpls te timer fast-reroutecommand to disable FRP polling.

The default FRR polling timer is 300 seconds.

n This command is not supported when the signaling protocol is CR-LDP.

Example # Set the FRR polling timer to 120 seconds or 2 minutes.

<Sysname> system-view [Sysname] mpls

[Sysname-mpls] mpls te timer fast-reroute 120

mpls te timer retry

Syntax mpls te timer retry second

undo mpls te timer retry

View Tunnel interface view

Parameter second: Interval for re-establishing the tunnel, in the range 1 to 4294967295 seconds.

Description Use the mpls te timer retry command to configure the interval for re-establishing the tunnel.

Use the undo mpls te timer retry command to restore the default.

The default interval for re-establishing a tunnel is 10 seconds.