3Com MSR 50 Interface dialer, Syntax interface dialer number Undo interface dialer number, 333

333

Table 32 Description on the fields of the display interface dialer command

Field	Description
LCP initial	LCP is initialized.
Physical is Dialer	The physical interface is a dialer interface.
Output queue : (Urgent queuing :	Statistics on the packets in the urgent output queue
Size/Length/Discards)
Output queue : (Protocol queuing	Statistics on the packets in the protocol output queue
: Length)
Output queue : (FIFO queuing :	Statistics on the packets in the FIFO output queue
Size/Length/Discards)
Last 300 seconds input: 0	Input interface data rate during the latest 300 seconds
bytes/sec, 0 packets/sec
Last 300 seconds output: 0	Output interface data rate during the latest 300 seconds
bytes/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops	Statistics on the packets reaching the interface
0 packets output, 0 bytes, 0 drops	Statistics on the packets sent through the interface

interface dialer

Syntax interface dialer number

undo interface dialer number

View System view

Parameter number: Dialer interface number, in the range 0 to 1023.

Description Use the interface dialer command to create a dialer interface. In C-DCC, this equals creating a dialer circular group.

Use the undo interface dialer command to remove a dialer interface.

By default, no dialer interface is created.

The dialer interface has a fixed baudrate of 64,000 bps.

In C-DCC, you may assign multiple physical interfaces to a dialer interface to inherit the attributes of this dialer interface by assigning them to the dialer circular group for the dialer interface with the dialer circular-groupcommand. This is efficient where calling multiple destinations simultaneously is desired, because instead of configuring individual physical interfaces, you only need to configure multiple dialer routes on the dialer interface.

In RS-DCC, any dialer interface can use the services provided by multiple physical interfaces, and individual physical interfaces can provide services for multiple dialer interfaces at the same time. Therefore, authentication must be configured on these physical interfaces, so as to use the username of a dial-in party to locate the corresponding dialer interface for the call. In this mode, physical interfaces and dialer interfaces are dynamically bound. Furthermore, a dialer interface can only call a destination address as specified in the dialer number command.