3Com MSR 30, MSR 50 manual # Display the state of all PoE interfaces

2488 CHAPTER 166: POE CONFIGURATION COMMANDS

Table 640 Description on fields of the display poe interface ethernet command

Field	Description
Port Power Mode	Power mode of a PoE interface:
	■ signal: Power is supplied over signal cables.
	■ spare: Power is supplied over spare cables.
	Different models of device support different power supply
	modes.
Port Current Power	Current power of a PoE interface, including PD consumption
	power and transmission loss
	The transmission loss usually does not exceed one watt. The
	specific loss depends on the device model.
Port Average Power	Average power of a PoE interface
Port Peak Power	Peak power of a PoE interface
Port Max Power	Maximum power of a PoE interface
Port Current	Current of a PoE interface
Port Voltage	Voltage of a PoE interface
Port PD Description	Description of the PD connected to the PoE interface, which is
	used to identify the type and location of the PD.

# Display the state of all PoE interfaces.

<Sysname> display poe interface
Interface	Enable	Priority	CurPower	Operating	IEEE	Detection
			(W)	Status		class Status
GE0/1	enable	low	4.4	on	1	delivering-power
GE0/2	enable	critical	0	on	-	disabled
GE0/3	enable	low	0	on	-	disabled
GE0/4	enable	critical	0	on	-	searching
GE0/5	enable	low	4.0	on	2	delivering-power
GE0/6	enable	low	0	on	-	disabled
GE0/7	disable	low	0	off	-	fault
GE0/8	disable	low	0	off	-	disabled
GE0/9	disable	low	0	off	-	disabled
GE0/10	disable	low	0	off	-	disabled
GE0/11	disable	low	0	off	-	disabled
GE0/12	disable	low	0	off	-	disabled

--- 2 port(s) on, 8.4(W) consumed, 171.6(W) Remaining ---

Table 641 Description on fields of the display poe interface command

Field	Description
Interface	Shortened form of a PoE interface
Enable	PoE enabled/disabled state:
	■ enable: PoE is enabled.
	■ disable: PoE is disabled.
Priority	Power priority of a PoE interface:
	■	critical (highest)
	■	high
	■	low
CurPower	Current power of a PoE interface