3Com MSR 30, MSR 50 manual Secondary accounting Hwtacacs scheme view

1984 CHAPTER 129: HWTACACS CONFIGURATION COMMANDS

Related command: reset stop-accounting-buffer,hwtacacs scheme, display stop-accounting-buffer.

Example # Set the maximum number of stop-accounting request transmission attempts to 50.

<Sysname> system-view

[Sysname] hwtacacs scheme hwt1

[Sysname-hwtacacs-hwt1] retry stop-accounting 50

secondary accounting (HWTACACS scheme view)

Syntax secondary accounting ip-address [ port-number ]

undo secondary accounting

View HWTACACS scheme view

Parameter ip-address: IP address of the server, a valid unicast address in dotted decimal notation. The default is 0.0.0.0.

port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.

Description Use the secondary accounting command to specify the secondary HWTACACS accounting server.

Use the undo secondary accounting command to remove the configuration.

Note that:

■The IP addresses of the primary and secondary accounting servers cannot be the same. Otherwise, the configuration fails.

■The HWTACACS service port configured on the device and that of the HWTACACS server must be consistent.

■If you configure the command for more than one time, the last configuration takes effect.

■You can remove an accounting server only when no active TCP connection for sending accounting packets is using it.

Example # Configure the secondary accounting server.

<Sysname> system-view

[Sysname] hwtacacs scheme hwt1

[Sysname-hwtacacs-hwt1] secondary accounting 10.163.155.12 49

secondary authentication (HWTACACS scheme view)

Syntax secondary authentication ip-address[ port-number]