1958 CHAPTER 128: RADIUS CONFIGURATION COMMANDS

View RADIUS scheme view

Parameter ip-address: IP address in dotted decimal notation. It must be an address of the device and cannot be all 0s address, all 1s address, a class D address, a class E address or a loopback address.

Description Use the nas-ipcommand to set the IP address for the device to use as the source address of the RADIUS packets to be sent to the server.

Use the undo nas-ipcommand to remove the configuration.

By default, the source IP address of a packet sent to the server is the IP address of the outbound port.

Note that:

Specifying a source address for the RADIUS packets to be sent to the server can avoid the situation where the packets sent back by the RADIUS server cannot reach the device as the result of a physical interface failure. The address of a loopback interface is recommended.

The nas-ipcommand in RADIUS scheme view is only for the current RADIUS scheme, while the radius nas-ipcommand in system view is for all RADIUS schemes. However, the nas-ipcommand in RADIUS scheme view overwrites the configuration of the radius nas-ipcommand.

Related command: radius nas-ip.

Example # Set the IP address for the device to use as the source address of the RADIUS packets to 10.1.1.1.

<Sysname> system-view

[Sysname] radius scheme test1

[Sysname-radius-test1] nas-ip 10.1.1.1

primary accounting (RADIUS scheme view)

Syntax primary accounting ip-address [ port-number ]

undo primary accounting

View RADIUS scheme view

Parameter ip-address: IP address of the primary accounting server.

port-number: UDP port number of the primary accounting server, which ranges from 1 to 65535.

Description Use the primary accounting command to configure the IP address and UDP port of the primary RADIUS accounting server.

Page 1958
Image 1958
3Com MSR 30, MSR 50 manual Primary accounting Radius scheme view, Related command radius nas-ip, Undo primary accounting