3Com MSR 50, MSR 30 manual # Restore the default dialing process for the access number, 2739

2739

is implemented by identifying the calling number. If the authentication succeeds, the voice gateway plays prompt tones, requiring the user to dial a called number. In addition, you can configure the number of redial attempts by using the redialtimes command, and the language in which the prompt tones are played by using the selectlanguage command.

Description Use the process-configcommand to specify a dialing process for an access number.

Use the undo process-configcommand to restore the default dialing process for an access number.

By default, the caller number process with IVR is specified for all access numbers.

Each access number has a specific dialing process. Calls originated by users who dial a certain access number are established in accordance with the same dialing process.

Differences between the caller number process and the caller number process with IVR are as follows:

■In the caller number process, after a user dials an access number, the voice gateway plays only dial tones (long tones).

■In the caller number process with IVR, after a user dials an access number, the voice gateway will play prompt tones, requiring the user to dial a called number.

In the card number/password process, with the authentication function disabled, a user can enter any two numbers as a card number and password respectively to make an IP call as long as they meet the length requirements.

After a dialing process is specified, parameters not related to the process are set to the default values and the corresponding commands are unavailable. Parameters related to the card number/password process include number of digits in a card number and number of digits in a password. The language selection function is applicable only to the caller number process with IVR, while the number of redial attempts is applicable to only the card number/password process and the caller number process with IVR.

Related command: gw-access-number,card-digit,password-digitand selectlanguage.

Example # Specify the dialing process for the access number 17909 as card number/password process.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] dial-program

[Sysname-voice-dial] gw-access-number 17909 [Sysname-voice-dial-anum17909] process-config cardnumber

# Restore the default dialing process for the access number 17909.

[Sysname-voice-dial-anum17909] undo process-config