3Com MSR 50, MSR 30 manual Voip called-start, Voip timer, Fast-connect

2621

Example # Disable the tunnel function on the called gateway.

<Sysname> system-view [Sysname] voice-setup

[Sysname-voice] undo voip called-tunnel enable

voip called-start

Syntax	voip called-start { fast normal }
	undo voip called-start
View	Voice view
Parameter	fast: The called GW initializes calls in a fast way.
	normal: The called GW initializes calls in a non-fast way.
Description	Use the voip call-startcommand to configure a call initialization mode for the
	called GW.
	Use the undo voip call-startcommand to restore the default.
	By default, the fast connection mode is used for call initialization.
	As the process of faculty negotiation is omitted in fast connection procedures, the
	faculties of the two parties are determined by the GW. If a router acts as a calling
	GW, you can enable or disable fast connection for each channel of initiated calls. If
	it acts as a called GW, it will use or not use the fast connection mode to initialize
	calls depending on the parameters of the voip call-startcommand, in the case
	that the calling GW uses the fast connection mode.
Related command:	fast-connect.
Example	# Configure the called gateway to initialize calls in normal mode.
	<Sysname> system-view
	[Sysname] voice-setup
	[Sysname-voice] voip called-start normal

voip timer

Syntax	voip timer voip-to-pots time
	undo voip timer voip-to-pots
View	Voice view
Parameter	voip-to-potstime: Duration in seconds for switching from a VoIP entity to a
	backup POTS entity after a call failure, in the range of 3 to 30.