3Com MSR 30, MSR 50 manual Send-ring, Shutdown voice entity view, Syntax send-ring Undo send-ring

2608 CHAPTER 173: VOIP CONFIGURATION COMMANDS

send-ring

Syntax send-ring

undo send-ring

View Voice entity view

Parameter None

Description Use the send-ringcommand to enable the local end to play ringback tone.

Use the undo send-ringcommand to disable the local end to play ringback tone.

By default, the local end does not play ringback tone.

In VoIP view, this command is applicable only after the fast connection function is enabled. In POTS view, you can configure this command after you carry out the line command to bind a voice entity to a trunk (other than FXS voice subscriber line).

Example # Enable the local end to play ringback tone.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] dial-program [Sysname-voice-dial] entity 10 voip [Sysname-voice-dial-entity10] fast-connect

[Sysname-voice-dial-entity10] send-ring

shutdown (voice entity view)

Syntax shutdown

undo shutdown

View POTS/VoIP entity view

Parameter None

Description Use the shutdown command to change the management status of the specified voice entity from UP to DOWN.

Use the undo shutdown command to restore the default management status of the voice entity.

By default, the voice entity management status is UP.

Running command shutdown will cause the voice entity unable to make calls.