3Com MSR 30, MSR 50 manual X25 reverse-charge-accept, Related command x25 map

456CHAPTER 26: LAPB AND X.25 CONFIGURATION COMMANDS

According to X.25, the call reception packet of a call may or may not carry an address code group, depending on the specific network requirements. This command enables users to easily specify whether the call reception packet carries the calling DTE address.

Related command: x25 response called-address,x25 ignore called-address,x25 ignore calling-address.

Example # Specify that the call reception packet of a call sent from the X.25 interface Serial 2/0 carries the calling DTE address.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] x25 response calling-address

x25 reverse-charge-accept

Syntax x25 reverse-charge-accept

undo x25 reverse-charge-accept

View Interface view

Parameter None

Description Use the x25 reverse-charge-acceptcommand to enable this interface to accept the call with the reverse charging request user facility.

Use the undo x25 reverse-charge-acceptcommand to disable this function.

By default, this function is disabled.

This function does not affect any call without “reverse charging request”.

If you enable this function on an X.25 interface, all these calls that reach the interface will be accepted. If you enable this function for a certain address mapping by the option reverse-charge-acceptin the x25 map command, only such calls that reach the interface and map this address will be accepted, while other calls (carrying reverse charging request and not mapping this address) will be cleared.

Related command: x25 map.

Example # Enable Serial 2/0 to accept the call with the reverse charging request user facility.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] x25 reverse-charge-accept