3Com MSR 30, MSR 50 manual Dlsw bridge-set, Dlsw enable, Syntax dlsw enable Undo dlsw enable

342CHAPTER 21: BASIC DLSW CONFIGURATION COMMANDS

Table 37 Description on the fields of the display llc2 command

Field	Description
Role	Local role of LLC2 circuit
	■	primary" represents the end that initiated the circuit
	■	secondary" represents the end accepted the circuit connection
State	State of the LLC2 circuit

dlsw bridge-set

Syntax dlsw bridge-set bridge-set

undo dlsw bridge-set bridge-set

View System view

Parameter bridge-set: ID of the bridge set to be mapped to DLSw, in the range of 1 to 63.

Description Use the dlsw bridge-setcommand to map the specified bridge set to DLSw.

Use the undo dlsw bridge-setcommand to remove mapping between the specified bridge set and DLSw.

By default, no bridge set is mapped to DLSw.

To enable forwarding frames of a bridge set to the remote end over a TCP connection, the local bridge set needs to be mapped to DLSw through this command. This command can be used repeated to map multiple bridge sets to DLSw.

For details about bridge set configuration, refer to “Bridging Configuration

Commands” on page 549.

Example # Map the bridge set by the ID of 20 connected to DLSw.

<Sysname> system-view

[Sysname] bridge enable

[Sysname] bridge 20 enable

[Sysname] dlsw bridge-set 20

dlsw enable

Syntax dlsw enable

undo dlsw enable

View System view

Parameter None