223

Description Use the error-diffusion restraint config command to set the three parameters in error packet diffusion restraint.

Use the undo error-diffusion restraint enable command to restore the default settings of the three parameters.

By default, the error packet detect timer is set to 30 seconds, the renew timer is set to 600 seconds, and the error packet ratio threshold is 20.

The setting of renew timer must be at least four times that of the error packet detect timer. If the total number of the packets received during detect-timeris less than 100, error packets are not counted.

n The support for these two commands varies with device models.

These two commands apply to CT1/PRI interfaces and CE1/PRI interfaces only.

Example # Set the error packet detect timer to 100 seconds, the renew timer to 2400 seconds, and the error packet ratio threshold to 15.

<Sysname> system-view

[Sysname] error-diffusion restraint config 100 2400 15

error-diffusion restraint enable

Syntax error-diffusion restraint enable

undo error-diffusion restraint enable

View System view

Parameter None

Description Use the error-diffusion restraint enable command to enable error packet diffusion restraint.

Use the undo error-diffusion restraint enable command to disable error packet diffusion restraint.

By default, the function is disabled.

n The support of these two commands varies with device model.

These two commands apply to CT1/PRI interfaces and CE1/PRI interfaces only.

Example # Enable error packet diffusion restraint.

<Sysname> system-view

[Sysname] error-diffusion restraint enable

Page 223
Image 223
3Com MSR 50, MSR 30 manual By default, the function is disabled, Example # Enable error packet diffusion restraint, 223