3Com MSR 50, MSR 30 manual Display poe interface power, 2489

2489

Table 641 Description on fields of the display poe interface command

Field	Description
Operating Status	Operating state of a PoE interface
	■ off: PoE is disabled.
	■ on: Power is supplied for a PoE interface normally.
	■ power lack: The guaranteed remaining power of the PSE is not high
	enough to supply power for a critical PoE interface.
	■ power-deny: The PSE refuses to supply power. The power required by
	the powered device (PD) is higher than the configured power.
	■ power-itself: The external equipment is supplying power for itself.
	■ power-limit: The PSE is supplying a limited power. The power required
	by the PD is higher than the configured power and the PSE still supplies
	the configured power.
	Different models of device support different operating states.
IEEE class	PD power class stipulated by IEEE
Detection Status	Power detection state of a PoE interface:
	■ disabled: The PoE function is disabled.
	■ searching: The PoE interface is searching for the PD.
	■ delivering-power: The PoE interface is supplying power for the PD.
	■ fault: There is a fault defined in 802.3af.
	■ test: The PoE interface is under test.
	■ There is a fault other than defined in 802.3af.
	■ pd-disconnect: The PD is disconnected.
	Different models of device support different power detection states.
port(s) on	Number of PoE interfaces that are supplying power
consumed	Power consumed by the current PoE interface
Remaining	Total remaining power of the system

display poe interface power

Syntax display poe interface power [ interface-type interface-number ]

View Any view

Parameter interface-typeinterface-number: Specifies an interface by its type and number.

Description Use the display poe interface power command to display the power information of a PoE interface(s).

If no interface is specified, the power information of all PoE interfaces is displayed.

Example # Display the power information of Ethernet 1/0.

<Sysname> display poe interface power ethernet 1/0

Interface	CurPower PeakPower MaxPower PD Description
	(W)	(W)	(W)
Eth1/0	15.0	15.3	15.4	Acess Point on Room 509 for Peter