3Com MSR 50 Debugging bgp detail, Syntax debugging bgp detail Undo debugging bgp detail, 1017

				1017
		Length: 19
*Aug	24	15:32:02:674 2006	Sysname	RM/6/RMDEBUG:
BGP.		: 10.1.1.2 Current event is RecvKeepAliveMessage.
*Aug	24	15:32:02:674 2006	Sysname	RM/6/RMDEBUG:

BGP.: 10.1.1.2 State is changed from OPENCONFIRM to ESTABLISHED.

// BGP has established the peer relationship successfully.

n The display above is the debugging information shown by executing the debugging bgp all command on Device A. If the peer relationship between two devices cannot be established, you can compare the above debugging information with the actual debugging information to locate the fault. For detailed descriptions on the specific messages, refer to the commands below.

debugging bgp detail

Syntax debugging bgp detail

undo debugging bgp detail

View User view

Default Level 1: Monitor level

Parameters None

Description Use the debugging bgp detail command to enable detailed debugging for BGP.

Use the undo debugging bgp detail command to disable detailed debugging for BGP.

Enabling debugging may affect system performance; therefore, use this command only when necessary. Disable debugging once the debugging operation is complete.

By default, detailed debugging for BGP is disabled.

Table 224 Description on the fields of the debugging bgp detail command

Field Description

BGP.xxx

BGP can’t get physical interface index for destination:X.X.X.X

Fail to search Token for destination X.X.X.X

Allocate token failed. destination= X.X.X.X,LspmErr=X

There are XX routes allocate token failed at this time before

BGP instance name

BGP cannot get the physical interface index for destination X.X.X.X.

Token search for destination X.X.X.X failed.

Failed to allocate Token: destination X.X.X.X, LSP error code X

Failed to allocate Tokens for XX routes

Recv UPDATE with following RD XXX Received an Update message with RD XXX