3Com MSR 50, MSR 30 manual Dlsw ethernet-frame-filter, # Enable DLSw, 343

343

Description Use the dlsw enable command to enable DLSw.

Use the undo dlsw enable command to disable DLSw.

By default, DLSw is enabled.

The execution of the undo dlsw enable command releases all dynamic resources without altering the configuration.

Example # Disable DLSw without changing the configuration.

<Sysname> system-view [Sysname] undo dlsw enable

# Enable DLSw.

<Sysname> system-view [Sysname] dlsw enable

dlsw ethernet-frame-filter

Syntax dlsw ethernet-frame-filter acl-number{ inbound outbound }

undo dlsw ethernet-frame-filter { inbound outbound }

View System view

Parameter acl-number: Layer 2 ACL number, in the range of 4000 to 4999.

inbound: Specifies to apply the ACL for inbound traffic.

outbound: Specifies to apply the ACL for outbound traffic.

Description Use the dlsw ethernet-frame-filtercommand to configure the DLSw router to filter Ethernet frames from or to the local SNA device by applying the specified ACL for inbound or outbound traffic.

Use the undo dlsw ethernet-frame-filtercommand to remove the ACL applied for the inbound or outbound traffic.

For more information about a Layer 2 ACL, refer to “IPv4 ACL Configuration Commands” on page 2087 and “IPv6 ACL Configuration Commands” on page 2103.

Example # Apply ACL 4000 on the DLSw router to filter inbound Ethernet frames.

<Sysname> system-view

[Sysname] dlsw ethernet-frame-filter 4000 inbound