3Com MSR 50, MSR 30 Ospfv3 area, Undo ospfv3 process-id, Related commands router-id, 1299

1299

<Sysname> system-view

[Sysname] ospfv3 1

[Sysname-ospfv3-1] maximum load-balancing 6

ospfv3

Syntax ospfv3 [ process-id ]

undo ospfv3 [ process-id]

View System view

Parameters process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535. The process ID defaults to 1.

Description Use the ospfv3 command to enable an OSPFv3 process and enter OSPFv3 view.

Use the undo ospfv3 command to disable an OSPFv3 process.

The system runs no OSPFv3 process by default.

Related commands: router-id.

n An OSPFv3 process can run normally only when Router ID is configured in OSPFv3 view. Otherwise, you can find the process, but which cannot generate any LSA.

Examples # Enable the OSPFv3 process with process ID as 120 and configure the Router ID as 1.1.1.1.

<Sysname> system-view

[Sysname] ospfv3 120

[Sysname-ospfv3-120] router-id 1.1.1.1

ospfv3 area

Syntax ospfv3 process-id area area-id [ instance instance-id ]

undo ospfv3 process-id area area-id [ instance instance-id ]

View Interface view

Parameters process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.

area-id: The ID of an area, a decimal integer (in the range of 0 to 4294967295) that is translated into IPv4 address format by the system or an IPv4 address.

instance-id: The instance ID of an interface, in the range of 0 to 255, which defaults to 0.