3Com MSR 30 Duplex, Flow-control, Syntax duplex auto full half Undo duplex, Related command speed

168CHAPTER 8: GENERAL ETHERNET INTERFACE CONFIGURATION COMMANDS

Table 12 Description on the fields of the display interface command (in bridge mode)

Field Description

Input (total):

Input (normal):

Input:

Output (total):

Output (normal):

Output:

Error statistics on the interface inbound and outbound packets, underscore indicates that the corresponding entry is invalid

duplex

Syntax duplex { auto full half }

undo duplex

View Ethernet interface view

Parameter auto: Indicates that the interface is in an auto-negotiation state. full: Indicates that the interface is in a full-duplex state.

half: Indicates that the interface is in a half-duplex state.

Description Use the duplex command to configure the duplex mode for an Ethernet interface.

Use the undo duplex command to restore the duplex mode for an Ethernet interface to the default.

By default, the duplex mode for an Ethernet interface is auto.

Related command: speed.

Example # Configure the interface Ethernet 1/0 to work in full-duplex mode.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] duplex full

flow-control

Syntax flow-control

undo flow-control

View Ethernet interface view