3Com MSR 30, MSR 50 manual Qos gts, Undo qos gts any acl acl-number queue queue-number

1776 CHAPTER 106: TRAFFIC SHAPING CONFIGURATION COMMANDS

Table 474 Description on the fields of the display qos gts command

Field	Description
Discarded	Number and byte number of discarded packets.
Delayed	Number and byte number of delayed packets.

qos gts

Syntax	qos gts { any acl acl-number } cir committed-information-rate [ cbs
	committed-burst-size [ ebs excess-burst-size ] [ queue-lengthqueue-length ] ]
	undo qos gts { any acl acl-numberqueue queue-number}
View	Interface view
Parameters	any: Performs TS on all the packets.
	acl acl-number: Performs TS on packets matching the ACL. acl-numberis the ACL
	number, in the range 2000 to 3999.
	cir committed-information-rate: CIR, in the range 8 to 1000000.
	cbs committed-burst-size: CBS, in the range 1875 to 19375000 bytes, with the
	default value being the traffic passed at CIR in 500 milliseconds. If the traffic
	passed at CIR in 500 milliseconds is lower than 1875, 1875 is taken as the default
	value.
	ebs excess-burst-size: EBS, i.e. size of the burst traffic exceeding the committed
	traffic in dual-token bucket algorithm, in the range 0 to 19375000 bytes. It
	defaults to 0, that is, only one token bucket is used for policing.
	queue-lengthqueue-length: The maximum length of the buffer, in the range 1 to
	1024. By default, queue-lengthis 50.
Description	Use the qos gts command to set shaping parameters for all or a specified type of
	traffic and perform traffic shaping.
	Use the undo qos gts command to remove the shaping configuration for all or a
	specified type of traffic.
	qos gts acl is used to set shaping parameters for the packets that conforms to
	certain ACL. Different ACLs can be used to set shaping parameters for different
	packets.
	qos gts any is used to set shaping parameters for all packets.
	The qos gts acl and qos gts any cannot be used at the same time. Only one can
	be used each time.
	By default, no shaping parameter is set on the interface.