3Com MSR 50, MSR 30 manual Delay wink-hold, Delay wink-rising, 2573

2573

[Sysname-voice-line1/0] em-signal wink

[Sysname-voice-line1/0] delay send-wink 700

delay wink-hold

Syntax delay wink-hold milliseconds

undo delay wink-hold

View E&M voice subscriber line view

Parameter wink-holdmilliseconds: Specifies duration (in milliseconds) the terminating side sends wink signals in the wink start mode. The value ranges from 100 to 3,000.

Description Use the delay wink-holdcommand to configure duration the terminating side sends wink signals in the wink start mode.

Use the undo delay wink-holdcommand to restore the default.

By default, the duration the terminating side sends wink signals is 500 milliseconds in the wink start mode.

Related command: em-signal.

Example # Set the duration the terminating side sends wink signals in the wink start mode to 700 milliseconds.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] subscriber-line 1/0 [Sysname-voice-line1/0] em-signal wink

[Sysname-voice-line1/0] delay wink-hold 700

delay wink-rising

Syntax delay wink-rising milliseconds

undo delay wink-rising

View E&M voice subscriber line view

Parameter wink-risingmilliseconds: Specifies the maximum amount of time (in milliseconds) the originating side waits for a wink signal after sending a seizure signal in the wink start mode. The value ranges from 100 to 5,000.

Description Use the delay wink-risingcommand to configure a maximum amount of time the originating side waits for a wink signal after sending a seizure signal in the wink start mode.