3Com MSR 50 Mpls te igp advertise, Description Example, # Set the hold time to 10000 milliseconds

1623

n

Example

You may perform the mpls te fast-reroutebypass-tunnelcommand multiple times to specify multiple bypass tunnels for the protected interface. At present, a maximum of three bypass tunnels can be specified for a protected interface.

When specifying a bypass tunnel, consider the following:

■The state of the tunnel must be up.

■The protected interface is not the outgoing interface in the route entries for the LSP of the bypass tunnel.

■A bypass tunnel cannot be used for services like VPN at the same time.

■This command is not supported when the signaling protocol is CR-LDP.

#Use Tunnel 0 as the bypass tunnel to protect the link connected to interface Ethernet 1/0.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] mpls te fast-reroute bypass-tunnel tunnel 0

mpls te igp advertise

Syntax mpls te igp advertise [ hold-time value ]

undo mpls te igp advertise

View Tunnel interface view

Parameter hold-timevalue: Sets the delay that IGP waits to notify IGP neighbors of the down event of the TE tunnel. It ranges from 0 to 4294967295 milliseconds. The default is 0 milliseconds.

Description

n

Example

Use the mpls te igp advertise command to enable IGP to advertise the MPLS TE tunnel as a link to IGP neighbors.

Use the undo mpls te igp advertise command to remove the configuration.

By default, IGP does not advertise MPLS TE tunnels to IGP neighbors.

The mpls te igp advertise command cannot be used together with the mpls te igp shortcut command.

# Set the hold time to 10000 milliseconds.

<Sysname> system-view

[Sysname] interface tunnel 0

[Sysname-Tunnel0] mpls te igp advertise hold-time 10000