3Com MSR 30, MSR 50 manual Info-center loghost source, Undo info-center loghost source

2438 CHAPTER 163: INFORMATION CENTER CONFIGURATION COMMANDS

Use the undo info-center loghost command to restore the default configurations on a log host.

By default, output of system information to the log host is disabled. When it is enabled, the default channel name will be loghost and the default channel number will be 2.

Note that:

■The info-center loghost command takes effect only after the information center is enabled with the info-center enable command.

■Ensure that the IP address input is correct while using the info-center loghost command to configure the IP address for a log host. System will prompt an invalid address if the loopback address (127.0.0.1) is input.

■A maximum number of 4 hosts (different) can be designated as the log host.

Example # Set to output log information to a Unix station with the IP address being 1.1.1.1/16.

<Sysname> system-view

[Sysname] info-center loghost 1.1.1.1

info-center loghost source

Syntax info-center loghost source interface-type interface-number

undo info-center loghost source

View System view

Parameter interface-typeinterface-number: Specifies a source interface by its type and number.

Description Use the info-center loghost source command to configure the source interface to output log information to the log host.

Use the undo info-center loghost source command to remove the source interface to output log information to the log host.

By default, no source interface is configured to output log information to the log host, and the system selects an interface as the source interface.

Note that the info-center loghost source command takes effect only after the information center is enabled with the info-center enable command.

Example # Configure the interface Serial 1/0 as the source interface to output log information to the log host.

<Sysname> system-view

[Sysname] info-center loghost source serial 1/0