3Com MSR 30, MSR 50 manual Field Description, Ais

270CHAPTER 17: FUNDAMENTAL CT3 INTERFACE CONFIGURATION COMMANDS

No code is sent now.

Periodical detection is enabled, no code received now.

BERT state:(stopped, not completed)

Test pattern: 2^7, Status: Not Sync, Sync Detected: 0

Time: 0 minute(s), Time past: 0 minute(s)

Bit errors (since test started): 0 bits

Bits received (since test started): 0 Mbits

Bit errors (since latest sync): 0 bits

Bits received (since latest sync): 0 Mbits

Historical Statistics:

Last clearing of counters: 14:39:02 UTC Sat 06/25/2005

Data in current interval (22 seconds elapsed):

0 Line Code Violations, 0 Far End Block Error

0 C-Bit Coding Violation, 0 P-bit Coding Violation

0 Framing Bit Err, 0 Severely Err Framing Secs

0 C-bit Err Secs, 0 C-bit Severely Err Secs

0 P-bit Err Secs, 0 P-bit Severely Err Secs

0 Unavailable Secs, 0 Line Err Secs

T3 2/0 CT1 1 is up

Frame-format ESF, clock slave, loopback not set

FDL Performance Report is disabled

Transmitter is sending none

Receiver alarm state is none

Line loop back deactivate code using inband signal last sent

BERT state:(stopped, not completed)

Test pattern: 2^11, Status: Not Sync, Sync Detected: 0

Time: 0 minute(s), Time past: 0 minute(s)

Bit errors (since test started): 0 bits

Bits received (since test started): 0 Kbits

Bit errors (since latest sync): 0 bits

Bits received (since latest sync): 0 Kbits

Table 21 Description on the fields of the display controller t3 command

Field	Description
T3 2/0 current state	Physical state of the interface: up or down
Description : T3 2/0 Interface	Description about the interface
Basic Configuration	Basic configurations of the interface
Work mode	Operating mode of the interface, CT3 or T3.
cable length	Cable length supported by the interface
Frame-format	Frame format: C-bit parity or M23
line code	In this output sample, line code is B3ZS.
Source clock	Clock source used by the interface: master for the
	internal clock or slave for the line clock
loopback	Loopback setting on the interface: local, remote,
	payload, or not set
Alarm State	Alarm state
Receiver alarm state	Type of the received alarm: none, LOS, LOF, RAI, or
	AIS.
	If a LOS, LOF, AIS was received, RAI would be sent and
	the screen displayed “Transmitter is sending RAI”
	instead.
MDL state	MDL state