3Com MSR 50, MSR 30 manual 1335

1335

protocol: Routing protocol, which can have any of the following values:

■bgp: Specifies the BGP protocol

■isis: Specifies the IS-IS protocol

■ospf: Specifies the OSPF protocol

■rip: Specifies the RIP protocol

process-id: Process number of the unicast routing protocol, in the range of 1 to 65535. This argument must be provided if IS-IS, OSPF or RIP is the specified unicast routing protocol.

policy-name: Name of the multicast route match rule, a case sensitive string of up to 19 characters.

rpf-nbr-address: IP address of the PPF neighbor.

interface-typeinterface-number: Specifies the interface type and number of an RPF neighbor. The interface type must not be Ethernet, GigabitEthernet, Loopback or Vlan-interface.

preference: Route preference, in the range of 1 to 255 and defaulting to 1.

order-number: Match order for routes on the same segment, in the range of 1 to 100.

Description Use the ip rpf-route-staticcommand to configure a multicast static route.

Use the undo ip rpf-route-staticcommand to delete a multicast static route from the multicast static routing table.

By default, no multicast static route is configured.

Note that:

■The arguments source-address { mask mask-length }, protocol and policy-name are critical elements in multicast static route configuration. The variation of any of these three arguments results in a different configuration.

■In the configuration, you can use the display multicast routing-table static command to check whether the multicast static route information contains this configuration. If you find a match, modify the corresponding fields without changing the configuration sequence; otherwise, add a multicast static route.

■When configuring a multicast static route, you cannot designate an RPF neighbor by specifying an interface (by means of the interface-typeinterface-numbercommand argument combination) if the interface type of that router is Ethernet, GigabitEthernet, Loopback or Vlan-interface; instead, you can designate an RPF neighbor only by specifying an address (rpf-nbr-address).

■Because outgoing interface iteration may fail or the specified interface may be in the down state, the multicast static route configured with this command may fail to take effect. Therefore, we recommend that you use the display multicast routing-table static command after you configure a multicast