Symphonic CHSP80G owner manual Functional Overview, Front Panel, Rear Panel

BeforeYou Start

Functional Overview

* The unit can also be turned on by pressing these buttons.

Front Panel

1 2 3 4 5 6 7* 8 9 10* 11

POWER DVR DVD

REC/OTR PAUSE STOP PLAY

CHANNEL

OPEN/CLOSE

16	15	14	13	12
Rear Panel
	17			18	19	20	21	22	23	24

VIDEO OUT

DIGITAL AUDIO OUTPUT	L		L
PCM/BITSTREAM
COAXIAL 2	R	1	R
	AUDIO OUT

COMPONENT	VIDEO IN
Y VIDEO OUTPUT		IN
PB/ S-VIDEO
CB	L
	R	OUT
PR/
CR	AUDIO IN ANTENNA
OUT

2625

1POWER indicator: Lights up when the power is on.

2DVR indicator: Lights up when DVR mode is selected.

3DVD indicator: Lights up when DVD mode is selected.

4I REC / OTR : Press once to start a basic recording. Press repeatedly to start an OTR (One Touch Recording). Each press increases the recording time by 30 minutes up to eight hours.

5F PAUSE : Press to pause playback or recording.

6C STOP : Press to stop playback or recording.

7BPLAY * : Press to start or resume playback. Press and hold for 5 seconds to set the Progressive Scan mode on / off. (DVD mode only)

8Remote control sensor: Receives signals from the remote control.

9Display: Shows information and messages.

10 A OPEN / CLOSE * : Press to open / close the disc tray.

11Disc tray: Place a DVD here.

12 D/ G (SKIP/FWD) : During playback, press to skip to the next title, chapter, or track. During playback, press and hold for 2 seconds for fast forward. When playback is paused, press and hold for 2 seconds for slow forward and press repeatedly for step by step playback.

13 H/E (SKIP/REV) : During playback, press to skip to the previous title, chapter, or track

During playback,press and hold for 2 seconds for fast reverse. When playback is paused, press and hold for 2 seconds for slow reverse and press repeatedly for step by step playback.

14 CHANNEL K / L: Press to change the channel.

15Device select button : Press to switch the device mode between DVR and DVD.

16POWER: Press to turn the unit on / off. The red LED is lit when the power is on.

17AC Power Cord: Connect to a standard AC outlet to supply power to this unit.

18COAXIAL DIGITAL AUDIO OUT: Connect an AV receiver, Dolby Digital decoder or other equipment with a coaxial digital input jack with an audio coaxial digital cable.

19VIDEO OUT: Connect the video input of a TV monitor, AV receiver, or other equipment here using the supplied video cable.

20COMPONENT VIDEO OUT: Connect the component video input of a TV monitor, AV receiver, or other equipment here using a commercially available component video cable. (DVD mode only)

21 S-VIDEO OUT: Connect the S-Video input of a TV monitor, AV receiver, or other equipment here using a commercially available S-Video cable.

22VIDEO IN(LINE1) : Connect the video output of an external device here using the supplied video cable.

23TV ANTENNA IN: Use to connect an antenna.

24TV ANTENNA OUT: Use to connect an antenna cable to pass the signal from the TV ANTENNA IN to your TV monitor.

25AUDIO IN(LINE1) : Connect an external equipment here using a supplied audio cables.

26AUDIO OUT : Connect the audio input of a TV monitor, AV receiver, or other equipment here using the supplied audio (L / R) cables.

Note: Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the unit.

10 EN