562CHAPTER 36: BRIDGING CONFIGURATION COMMANDS

Example # Clear the traffic statistics information about bridge set 1. <Sysname> reset bridge traffic bridge-set 1

x25 map bridge

Syntax

x25 map bridge x121-address x.121-addressbroadcast

 

undo x25 map bridge x121-address x.121-address

View

Interface view

Parameters

x121-addressx.121-address: X.121 address of the peer host.

 

broadcast: Enables bridging of broadcasts to the X.25 destination.

Description

Use the x25 map bridge command to create an X.25-to-bridging mapping.

 

Use the undo x25 map bridge command to remove an X25-to-bridging

 

mapping.

 

By default, no X.25-to-bridging mappings exist.

Related command:

display x25 map on page 426.

Example

# Create an X.25-to-bridging mapping on Serial2/0.

 

<Sysname> system-view

 

[Sysname] interface serial 1/0

 

[Sysname-Serial1/0] link-protocol x25

 

[Sysname-Serial1/0] x25 x121-address 100

 

[Sysname-Serial1/0] x25 map bridge x121-address 20112451 broadcast

 

[Sysname-Serial1/0] bridge-set 1

Page 562
Image 562
3Com MSR 30 manual X25 map bridge x121-address x.121-address broadcast, Undo x25 map bridge x121-address x.121-address