3Com MSR 50 Secondary authorization, Example # Configure the secondary authentication server

1985

undo secondary authentication

View HWTACACS scheme view

Parameter ip-address: IP address of the server, a valid unicast address in dotted decimal notation. The default is 0.0.0.0.

port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.

Description Use the secondary authentication command to specify the secondary HWTACACS authentication server.

Use the undo secondary authentication command to remove the configuration.

Note that:

■The IP addresses of the primary and secondary authentication servers cannot be the same. Otherwise, the configuration fails.

■The HWTACACS service port configured on the device and that of the HWTACACS server must be consistent.

■If you configure the command for more than one time, the last configuration takes effect.

■You can remove an authentication server only when no active TCP connection for sending authentication packets is using it.

Related command: display hwtacacs.

Example # Configure the secondary authentication server.

<Sysname> system-view

[Sysname] hwtacacs scheme hwt1

[Sysname-hwtacacs-hwt1] secondary authentication 10.163.155.13 49

secondary authorization

Syntax secondary authorization ip-address[ por-number t ]

undo secondary authorization

View HWTACACS scheme view

Parameter ip-address: IP address of the server, a valid unicast address in dotted decimal notation. The default is 0.0.0.0.

port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.