3Com MSR 30, MSR 50 manual X25 ignore called-address, X25 ignore calling-address

446CHAPTER 26: LAPB AND X.25 CONFIGURATION COMMANDS

Example # Create hunt group hg1 which uses cyclic selection policy.

<Sysname> system-view

[Sysname] x25 hunt-group hg1 round-robin

[Sysname-hg-hg1]

x25 ignore called-address

Syntax x25 ignore called-address

undo x25 ignore called-address

View Interface view

Parameter None

Description Use the x25 ignore called-addresscommand to enable it to ignore the X.121 address of the called DTE when X.25 initiates calls.

Use the undo x25 ignore called-addresscommand to disable this function.

By default, this function is disabled.

According to X.25, the calling request packet must carry the address. However, on some occasions, the X.25 calling request does not have to carry the called/calling DTE address in a specific network environment or as is required by the application. This command enables users to specify whether the call request packet sent by X.25 in the device carries the called DTE address.

Related command: x25 response called-address,x25 response calling-address,x25 ignore calling-address.

Example # Specify the call request packet from the X.25 interface Serial 2/0 not to carry the called DTE address.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] x25 ignore called-address

x25 ignore calling-address

Syntax x25 ignore calling-address

undo x25 ignore calling-address

View Interface view

Parameter None