3Com MSR 50, MSR 30 manual Reset counters controller e1 interface-number, Command

211

Use the undo pri-setcommand to remove the bundle.

By default, no PRI set is created.

On a CE1/PRI interface in PRI mode, timeslot 0 is used for frame synchronization control (FSC), timeslot 16 as the D channel for signaling transmission, and other timeslots as B channels for data transmission.

You can create only one PRI set on a CE1/PRI interface. This PRI set can include any timeslots except timeslot 0 and must include timeslot 16. Note that timeslot 16 cannot form a bundle that includes itself only. The attempt to bundle only timeslot 16 will fail.

If no timeslot is specified in this command, all timeslots except timeslot 0 are bundled into an interface in the form of 30B + D.

Upon creation of the PRI set, the system creates a serial interface logically equivalent to an ISDN PRI interface. The serial interface is named in the form of serial number:15, where number represents the number of the CE1/PRI interface where the serial interface is created.

Because a channel set and a PRI set cannot coexist on a CE1/PRI interface, your PRI set creation attempt will fail if the channel-setcommand is configured.

Example # Bundle timeslots 1, 2, and 8 through 12 into a PRI set on CE1/PRI interface E1 2/0.

<Sysname> system-view

[Sysname] controller e1 2/0

[Sysname-E1 2/0] pri-set timeslot-list 1,2,8-12

reset counters controller e1

Syntax	reset counters controller e1 interface-number
View	User view
Parameter	interface-number: Interface number.
Description	Use the reset counters controller e1 command to clear the controller counter
	for a CE1/PRI interface.
	To display the information of the controller counter, use the display controller e1
	command.
n	■ The reset counters interface command does not clear the controller counters
	of CE1/PRI interfaces. To do that, use the reset counters controller e1
	command.
	■ The controller counters information that is cleared using the reset counters
	controller e1 command is the same information that you can view with the
	display controller e1 [ interface-number ] command.