3Com MSR 30 manual Demand-refused digit-end nullnum req-billingcategory, With or without priority

2662 CHAPTER 175: E1 AND T1 CONFIGURATION COMMANDS

	[Sysname-e1 1/0] cas 0
	[Sysname-cas 1/0:0] re-answer enable
register-value
Syntax	register-value { billingcategory callcreate-in-groupa callingcategory congestion
	demand-refused digit-end nullnum req-billingcategory
	req-callednum-and-switchgroupa req-callingcategory req-
	currentcallednum-in-groupc req-currentdigit req- firstcallednum-in-groupc
	req-firstcallingnum req-firstdigit req-lastfirstdigit req-lastseconddigit
	req-lastthirddigit req-nextcallednum req-nextcallingnum req-switch-groupb
	subscriber-abnormal subscriber-busy subscriber-charge subscriber-idle } value
	undo register-value { billingcategory callcreate-in-groupa callingcategory
	congestion demand-refused digit-end nullnum req-billingcategory
	req-callednum-and-switchgroupa req-callingcategory req-
	currentcallednum-in-groupc req-currentdigit req- firstcallednum-in-groupc
	req-firstcallingnum req-firstdigit req-nextcallednum req-nextcallingnum
	req-lastfirstdigit req-lastseconddigit req-lastthirddigit req-nextcallednum req-
	nextcallingnum req-specialsignal req-switch-groupb subscriber-abnormal
	subscriber-busy subscriber-charge subscriber-idle }
View	R2 CAS view
Parameter	billingcategory value: Specifies the billing category value, in the range 1 to 16. It
	configures the KA signal in R2 signaling. The KA signal is sent by the originating
	point forward to the originating toll office or originating international exchange to
	indicate calling category. The signal provides two types of information for this call
	connection: billing category (regular, immediate, or toll free) and subscriber level
	(with or without priority).
	callcreate-in-groupavalue: Specifies the direct call setup signal value, in the
	range 1 to 16.
	callingcategory value: Specifies the calling category signal value, in the range 1
	to 16. It configures the R2 KD signal. It functions to identify whether break-in and
	forced- release can be implemented by or on the calling party.
	congestion value: Specifies the congestion signal value, in the range 1 to 16.
	demand-refusedvalue: Specifies the request-refused signal value, in the range 1
	to 16.
	digit-endvalue: Specifies the digit-end signal value, in the range 1 to 16.
	nullnum value: Specifies the null number signal value, in the range 1 to 16.
	req-billingcategoryvalue: Specifies the send billing category signal value, in the
	range 1 to 16.
	req-callednum-and-switchgroupavalue: Specifies the send last digit and
	changeover to Group A signal value, in the range 1 to 16.