3Com MSR 30, MSR 50 manual Rip authentication-mode, Undo rip authentication-mode

1174 CHAPTER 77: RIP CONFIGURATION COMMANDS

Parameters process-id: RIP process number, in the range of 1 to 65535. The default is 1.

vpn-instancevpn-instance-name: Specifies a VPN instance name, a string of 1 to 31 characters.

Description Use the rip command to create a RIP process and enter RIP view.

Use the undo rip command to disable a RIP process.

By default, no RIP process is enabled.

Note that:

■If no VPN instance is specified, the RIP process will run under public network instance.

■You must create a VPN instance before you apply a RIP process to it. For related configuration, refer to “ip vpn-instance” on page 1696.

■You must create the RIP process before configuring the global parameters. This rule does not apply to interface parameters.

■The configured interface parameters become invalid after you disable the RIP process.

Examples # Create a RIP process and enter rip process view.

<Sysname> system-view

[Sysname] rip

[Sysname-rip-1]

rip authentication-mode

Syntax	rip authentication-mode { md5 { rfc2082 key-stringkey-idrfc2453 key-string}
	simple password }
	undo rip authentication-mode
View	Interface view
Parameters	md5: MD5 authentication mode.
	rfc2453: Uses the message format defined in RFC 2453 (IETF standard).
	rfc2082: Uses the message format defined in RFC 2082.
	key-id: MD5 key number, in the range of 1 to 255.
	key-string: MD5 key string with 1 to 16 characters in plain text format, or 1 to 24
	characters in cipher text format. When the display current-configuration
	command is used to display system information, a 24-character cipher string is
	displayed as the MD5 key string.
	simple: Plain text authentication mode.