3Com MSR 30, MSR 50 Display voice fax, Example # Set the maximum fax rate to 9,600 bps globally

2680 CHAPTER 176: FAX OVER IP CONFIGURATION COMMANDS

local-train threshold threshold: Specifies the threshold percentage of fax local training (in the range of 0 to 100). The default value is 10.

nsf-on: Enables NSF message transmission. It is disabled by default.

protocol: Specifies the transport protocol of the fax. By default, the T.38 fax protocol is applied. Both hb-redundancynumber and lb-redundancynumber default to 0.

■standard-t38: Adopts the standard T.38 (UDP) fax protocol, which supports H.323-T.38 and SIP-T.38 protocols.

■pcm: Enables the passthrough mode.

■g711alaw: Adopts G.711 A-law.

■g711ulaw: Adopts G.711 μ-law.

■t38: Enables T.38 fax protocol.

■hb-redundancynumber: Number of redundant high-speed T.38 packets, in the range of 0 to 2.

■lb-redundancynumber: Number of redundant low-speed T.38 packets, in the range of 0 to 5.

train-mode: Specifies the fax training mode. By default, the point-to-point training mode is adopted.

■local: Adopts local training.

■ppp: Adopts point-to-point training.

Description Use the default entity fax command to set fax parameters to the default values globally.

Use the undo default entity fax command to restore the fax parameters of the system to the defaults.

n You must carry out the default entity fax train-mode local command before the configuration made by the default entity fax local-train threshold command takes effect.

Example # Set the maximum fax rate to 9,600 bps globally.

<Sysname> system-view

[Sysname] voice-setup

[Sysname-voice] dial-program

[Sysname-voice-dial] default entity fax baudrate 9600

display voice fax

Syntax display voice fax statistics

View Any view