3Com MSR 30, MSR 50 manual Qos pq, Related commands qos pq, qos pq pql, Examples # Display PQLs

1812 CHAPTER 112: PQ CONFIGURATION COMMANDS

Parameters pql-number: Priority queue list number.

Description Use the display qos pql command to view contents of specified PQ list (PQL) or all PQ lists.

Default items are not displayed.

Related commands: qos pq, qos pq pql.

Examples # Display PQLs.

<Sysname> display qos pql Current PQL Configuration:

List Queue Params

------------------------------------------------------

1 Top Protocol ip less-than 1000

2Normal Length 60

2Bottom Length 40

3Middle Inbound-interface Ethernet1/0

qos pq

Syntax qos pq pql pql-index

undo qos pq

View Interface view

Parameters pql: Uses the parameters defined in specified PQ list.

pql-index: PQL index, in the range 1 to 16.

Description Use the qos pq command to apply a group of priority list to an interface.

Use the undo qos pq command to restore the congestion management policy at the interface to FIFO.

By default, the congestion management policy at the interfaces is FIFO.

Except for interfaces encapsulated with X.25, all physical interfaces can use PQ.

An interface can only use one group of priority lists.

This command can configure multiple classification rules for each group in the priority list. During traffic classification, the system matches packets along the rule list. If matching a certain rule, a packet will be classified into the priority queue specified by this rule; or it will be put into the default priority queue.

Related commands: qos pql inbound-interface,display qos pq interface, display qos pql, display qos policy interface.