3Com MSR 50 Display bridge information, Syntax display bridge information bridge-set bridge-set

555

Table 90 Description on the fields of the display bridge address-table command

Field	Description
Set	Bridge set number
Flag	Flag can be any of the four values: P--PERMIT N--DENY
	D--DYNAMIC S--STATIC
	P: The permit rule is used for MAC address filtering
	N: The deny rule is used for MAC address filtering
	D: This entry is a dynamic entry
	S: This entry is a static entry
Aging-time	The aging time of bridge table entries
Receive	Number of received frames destined for this MAC address
Send	Number of forwarded frames destined for this MAC address
Interface-name	Outbound interface name

display bridge information

Syntax display bridge information [ bridge-set bridge-set]

View Any view

Parameters bridge-set: Bridge set number, an integer in the range of 1 to 255.

Description Use the display bridge information command to view the information about the specified bridge set or all bridge sets.

Example # View the information about all bridge sets.

<Sysname> display bridge information

Bridge module is activated,2 port take part in bridge module at all; Address table has 15 item, with 1 static one; life cycle is 300 (s).

Bridge set 1 :

configure :bridge 1 enable;

bridging ip, undo bridging ipx; bridging others; undo routing ip, undo routing ipx;

bridge 1 learning

interface :total 2 interface(s) in the set Ethernet1/0 : up

Ethernet1/1 : up Bridge set 2 :

configure :bridge 2 enable;

bridging ip, undo bridging ipx; bridging others; undo routing ip, undo routing ipx;

bridge 2 learning

interface :total 2 interface(s) in the set Ethernet1/0.1 :up Ethernet1/0.2 :up