3Com MSR 50, MSR 30 manual Related command register-valuereq-switch-groupb, 2657

2657

Description Use the group-b enable command to enable R2 signaling to use Group B signals to complete registers exchange.

Use the undo group-b enable command to disable R2 signaling from using

Group B signals to complete registers exchange.

By default, Group B signals are used to complete registers exchange.

This command applies to R2 signaling only.

You may need to configure the undo form of this command to accommodate to the R2 interregister signaling in some countries where Group B signals is not supported or cannot be interpreted correctly.

Related command: register-valuereq-switch-groupb.

Example # Adopt Group B signals to complete registers exchange.

<Sysname> system-view [Sysname] controller e1 1/0

[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2 [Sysname-e1 1/0] cas 0

[Sysname-cas1/0:0] group-b enable

line

Syntax line slot-number:{ts-set-number 15 23 }

undo line

View POTS voice entity view

Parameter slot-number:Number of the E1/T1 interface corresponding to a subscriber line.

ts-set-number: Number of the TS group created on the E1/T1 interface.

15: Indicates that the POTS voice entity is to be associated with an E1 voice ISDN PRI interface.

23: Indicates that the POTS voice entity is to be associated with a T1 voice ISDN PRI interface.

Description Use the line command to configure the binding between a POTS entity and a logical voice subscriber line.

Use the undo line command to remove the binding.

By default, there is no binding between a POTS entity and a logical voice subscriber line.

This command applies to both E1 and T1 voice.