3Com MSR 30, MSR 50 Entity entity-number pots voip, Undo entity entity-numberall pots voip

2594 CHAPTER 173: VOIP CONFIGURATION COMMANDS

View	E&M voice subscriber line view
Parameter	delay: When using the delay start mode, the calling end occupies the trunk line,
	and the called end, such as PBX, will also enter the hook-off state to respond the
	caller till it is ready for receiving the called number.
	immediate: Immediate start mode. The caller end hooks off to seize the line
	through line E and sends the called number. The prerequisite for using the
	immediate start mode is: The equipment at the remote end should listen to the
	dial signal immediately after identifying the off-hook signal.
	wink: Wink start mode. The caller end hooks off to seize the line through line E,
	and it has to wait for a wink signal from the remote end before sending out the
	called number.
Description	Use the em-signalcommand to configure a start mode for an analog E&M voice
	subscriber line.
	Use the undo em-signalcommand to restore the default start mode.
	By default, the immediate start mode is selected for the analog E&M subscriber
	line.
Related command:	delay.
Example	# Configure delay mode.
	<Sysname> system-view
	[Sysname] voice-setup
	[Sysname-voice] subscriber-line 1/0
	[Sysname-voice-line1/0] em-signal delay

entity

Syntax	entity entity-number{ pots voip }
	undo entity { entity-numberall pots voip }
View	Voice dial program view
Parameter	entity-number: Identifies a voice entity. The value ranges from 1 to 2147483647.
	all: All voice entities.
	pots: Indicates that the voice entity originates a call from the local voice subscriber
	line.
	voip: Indicates that the voice entity originates a call from the network side.
Description	Use the entity command to enter voice entity view, or configure a voice entity
	and then enter its view if the voice entity does not exist.