3Com MSR 30, MSR 50 manual Display ospfv3 vlink, Syntax display ospfv3 process-id vlink

1294 CHAPTER 84: IPV6 OSPFV3 CONFIGURATION COMMANDS

area-id: The ID of an area, a decimal integer (in the range of 0 to 4294967295) that is translated into IPv4 address format by the system or an IPv4 address.

Description Use the display ospfv3 topology command to display OSPFv3 topology information. If no process is specified, topology information of all OSPFv3 processes is displayed.

Examples # Display OSPFv3 area 1 topology information.

<Sysname> display ospfv3 topology area 1

		OSPFv3 Process (1)
OSPFv3 Area (0.0.0.1) topology
Type	ID(If-Index)	Bits	Metric	Next-Hop	Interface
Rtr	1.1.1.1		--
Rtr	2.2.2.2		1	2.2.2.2	Eth1/0
Rtr	3.3.3.3		1	3.3.3.3	Eth1/0
Rtr	4.4.4.4		1	4.4.4.4	Eth1/0
Net	4.4.4.4(983049)		1	0.0.0.0	Eth1/0
Table 314 Description on the fields of the display ospfv3 topology command
Field				Description
Type				Type of node
ID(If-Index)				Router ID
Bits				Flag bit
Metric				Cost value
Next-Hop				Next hop
Interface				Outbound interface

display ospfv3 vlink

Syntax display ospfv3 [ process-id] vlink

View Any view

Parameters process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.

Description Use the display ospfv3 vlink command to display OSPFv3 virtual link information. If no process is specified, virtual link information of all OSPFv3 processes is displayed.

Examples # Display OSPFv3 virtual link information.

<Sysname> display ospfv3 vlink

Virtual Link VLINK1 to router 1.1.1.1 is up

Transit area :0.0.0.1 via interface Serial2/0, instance ID: 0

Local address: 2000:1::1

Remote address: 2001:1:1::1

Transmit Delay is 1 sec, State: P-To-P,

Timer intervals configured, Hello: 10, Dead: 40, Wait: 40, Re transmit: 5