3Com MSR 30 Ripng default-route, Ripng enable, Syntax ripng process-idenable Undo ripng enable

1318 CHAPTER 85: IPV6 RIPNG CONFIGURATION COMMANDS

[Sysname] undo ripng 100

ripng default-route

Syntax ripng default-route { only originate } [ cost cost ]

undo ripng default-route

View Interface view

Parameters only: Indicates that only the IPv6 default route (::/0) is advertised via the interface.

originate: Indicates that the IPv6 default route (::/0) is advertised without suppressing other routes.

cost: Metric of the advertised default route, in the range of 1 to 15, with a default value of 1.

Description Use the ripng default-routecommand to advertise a default route with the specified routing metric to a RIPng neighbor.

Use the undo ripng default-routecommand to stop advertising and forwarding the default route.

By default, a RIP process does not advertise any default route.

After you execute this command, the generated RIPng default route is advertised in a route update over the specified interface. This IPv6 default route is advertised without considering whether it already exists in local IPv6 routing table.

Examples # Advertise only the default route via Ethernet 1/0.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] ripng default-route only

# Advertise the default route together with other routes via Ethernet1/0.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] ripng default-route originate

ripng enable

Syntax ripng process-idenable

undo ripng enable

View Interface view