3Com MSR 30, MSR 50 Display traffic behavior, Qos policy , traffic behavior , classifier behavior

1792 CHAPTER 109: DEFINING TRAFFIC BEHAVIOR COMMANDS

Description	Use the car command to configure traffic monitoring for a traffic behavior.
	Use the undo car command to delete the configuration of traffic monitoring.
	The policy can be used in the input or outbound direction of the interface.
	Application of policy including of TP policy on an interface will cause the previous
	qos car command ineffective.
	If this command is frequently configured on classes of the same policy, the last
	configuration will overwrite the previous ones.
Related commands:	qos policy, traffic behavior, classifier behavior.
Examples	# Use traffic monitor for a behavior. The normal traffic of packets is 200 kbps.
	Burst traffic twice of the normal traffic can pass initially and later the traffic is
	transmitted normally when the rate does not exceed 200 kbps. When the rate
	exceeds 200 kbps, the IP precedence of the packet turns to 0 and the packet is
	transmitted.
	<Sysname> system-view
	[Sysname] traffic behavior database
	[Sysname-behavior-database] car cir 200 cbs 50000 ebs 0 green pass r
	ed remark-prec-pass 0

display traffic behavior

Syntax	display traffic behavior { system-defined user-defined } [ behavior-name]
View	Any view
Parameters	system-defined: Behavior pre-defined by the system.
	user-defined: Behavior pre-defined by the user.
	behavior-name: Behavior name. If it is not specified, the information of the
	behaviors pre-defined by the system or by the user will be displayed.
Description	Use the display traffic behavior command to display the information of the
	traffic behavior configured on the router.
Examples	# Display information about user-defined traffic behavior.
	<Sysname> display traffic behavior user-defined
	User Defined Behavior Information:
	Behavior: test
	Assured Forwarding:
	Bandwidth 30 (Kbps)
	Discard Method: Tail
	Queue Length : 64 (Packets)
	General Traffic Shape:
	CIR 300 (kbps), CBS 15000 (byte), EBS 0 (byte)