3Com MSR 50, MSR 30 161, System Debugging Commands, Undo debugging all module-name option, 2403

2403

161

SYSTEM DEBUGGING COMMANDS

debugging

Syntax debugging { all [ timeout time ] module-name [ option ] }

undo debugging { all module-name[ option ] }

View User view

Parameter all: All debugging functions.

timeout time: Specifies the timeout time for the debugging all command. When all debugging is enabled, the system automatically executes the undo debugging all command after the time. The value ranges from 1 to 1440, in minutes.

module-name: Module name, such as ARP or ATM. You can use the debugging ? command to display the current module name.

option: Specifies the debugging option for a specific module. Different modules have different debugging options in terms of their number and content. You can use the debugging module-name? command to display the currently supported options.

Description Use the debugging command to enable the debugging of a specific module.

Use the undo debugging command to disable the debugging of a specific module.

By default, debugging functions of all modules are disabled.

Note the following:

■This command is intended for network administrators to diagnose network failure.

■Output of the debugging information may degrade system efficiency, especially during the execution of the debugging all command. Therefore, use the command with caution.

■After finishing debugging, you can use the undo debugging all command to disable all the debugging functions.

■You must configure the debugging, terminal debugging and terminal monitor commands first to display detailed debugging information on the