3Com MSR 50 Callmode, Cas, Related command re-answer enable and timer dl re-answer, Undo callmode

2649

By default, the originating party requires the terminating party to send answer signal.

This command applies to R2 signaling only.

The R2 line signaling coding schemes in some countries do not include answer signal sending. To accommodate to such schemes, you must configure the answer enable command on the originating point. This allows the terminating point to set up calls after a specified time period.

Related command: re-answer enable and timer dl re-answer.

Example # Configure the originating point to disable the terminating point from sending answer signals.

<Sysname> system-view [Sysname] controller e1 1/0

[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2 [Sysname-e1 1/0] cas 0

[Sysname-cas1/0:0] undo answer enable

callmode

Syntax	callmode { segment terminal }
	undo callmode
View	R2 CAS view
Parameter	segment: Specifies the connection mode for an R2 call as segment-to-segment.
	terminal: Specifies the connection mode for an R2 call as terminal-to-terminal.
Description	Use the callmode command to configure the connection mode for an R2 call.
	Use the undo callmode command to restore the default setting.
	By default, the connection mode for an R2 call is terminal.
Example	# Set the connection mode for an R2 call to segment.
	<Sysname> system-view
	[Sysname] controller e1 1/0
	[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
	[Sysname-e1 1/0] cas 0
	[Sysname-cas 1/0:0] callmode segment

cas

Syntax cas ts-set-number