3Com MSR 30, MSR 50 manual Process-config, Related command gw-access-numberand process-config

2738 CHAPTER 180: VOICE RADIUS CONFIGURATION COMMANDS

Use the undo password-digitcommand to restore the default number of digits in a password for some access number in the card number/password process.

This command is unavailable for the caller number process with IVR. By default, the number of digits in a password for some access number in the card number/password process is 6.

Before executing the password-digitcommand, you must use the process-configcommand to specify the two-stage dialing process for the configured access number as card number/password process. The password-digitcommand is available only in access number view.

Related command: gw-access-numberand process-config.

Example # Specify the number of digits in a password as 4 for the access number 17909.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] dial-program

[Sysname-voice-dial] gw-access-number 17909 [Sysname-voice-dial-anum17909] process-config cardnumber

[Sysname-voice-dial-anum17909] password-digit 4

#Restore the default number of digits in a password for the access number 17909.

[Sysname-voice-dial-anum17909] undo password-digit

process-config

Syntax process-config { callernumber cardnumber voice-caller }

undo process-config

View Access number view

Parameter callernumber: Specifies the two stage-dialing process as caller number process. After a user dials an access number, the voice gateway will continue to play dial tones, prompting for a called number. In this process, the user authentication is implemented by identifying the calling number, and no more additional parameter configurations are required.

cardnumber: Specifies the two-stage dialing process as card number/password process. After a user dials an access number, the voice gateway will continue to play prompt tones, requiring the user to enter a card number and password. In this process, the user authentication is implemented by identifying the prepaid card number and password, and you can configure parameters by using the card-digit, password-digit, and redialtimes commands.

voice-caller: Specifies the two-stage dialing process as caller number process with IVR. After a user dials an access number, the voice gateway will play prompt tones, requiring the user to dial a called number. In this process, the user authentication