3Com MSR 50, MSR 30 manual Mode and parameters, Format defined in RFC, Interface view, Messages

	1175
	password: Plain text authentication string with 1 to 16 characters.
Description	Use the rip authentication-modecommand to configure RIP-2 authentication
	mode and parameters.
	Use the undo rip authentication-modecommand to cancel authentication.
	Note that the key string you configured can overwrite the old one if there is any.
Related commands:	rip version.
n	With RIPv1, you can configure the authentication mode in interface view.
	However, the configuration will not take effect because RIPv1 does not support
	authentication.
Examples	# Configure MD5 authentication on Ethernet1/0 with the key string being rose in
	the format defined in RFC 2453.
	<Sysname> system-view
	[Sysname] interface ethernet 1/0
	[Sysname-Ethernet1/0] rip version 2
	[Sysname-Ethernet1/0] rip authentication-mode md5 rfc2453 rose
rip input
Syntax	rip input
	undo rip input
View	Interface view
Parameters	None
Description	Use the rip input command to enable the interface to receive RIP messages.
	Use the undo rip input command to disable the interface from receiving RIP
	messages.
	By default, an interface is enabled to receive RIP messages.
Related commands:	rip output.
Examples	# Enable Ethernet1/0 to receive RIP messages.
	<Sysname> system-view
	[Sysname] interface ethernet1/0
	[Sysname-Ethernet1/0] rip input